***PLEASE STOP***
Click HEADSET SHORTAGE before ordering or calling for the latest information and availability.

How to Place a Call on Your Wireless Headset without a Handset Lifter or EHS Cable

Desk Phone (standard)

1 Connect one end of the telephone interface cable to the back of the base.
2 Disconnect the handset coil cord from the desk phone and re-connect it to the telephone
interface cable junction box.
3 Connect the remaining end of the telephone interface cable into the open handset port on the
desk phone.

NOTE: Your desk phone handset will continue to work; it’s just hooked up differently.

 

Wireless Headset Setup and Installation

NOTE: If your phone has a built-in headset port, you should only use the headset port if you will not be using the HL10 lifter. In this configuration, you must press both the headset button on your phone and the call control button on the headset to answer or end calls.

 

To place a call using your wireless headset:

Step 1: to place a call, you must pick up your handset receiver and set it off to the side of your phone (you should have a dial tone at this time in the handset receiver) then push the on/off button on the side of the headset.

Step 2: to end the call, push the on/off button on the side of your wireless headset and then replace the handset receiver back into the cradle on your phone.

To answer a call using your wireless headset:

Step 1: to answer a call, you must pick up your handset receiver and set it off to the side of your phone (you should have a dial tone at this time in the handset receiver) then push the on/off button on the side of the headset.

Step 2: to end the call, push the on/off button on the side of your wireless headset and then replace the handset receiver back into the cradle on your phone.

Note: If you want to use the handset receiver and not the wireless headset, do not turn the headset on.

Leave a Reply

Your email address will not be published. Required fields are marked *