How to fix headset static with 3.5 mm stereo jack.

(Also applies to headset static when using 2.5 mm stereo jack and 1/8th stereo jack)

We often hear customers having issues with 3.5mm stereo jacks where there is occasional and sometimes constant static.  Typically the issue is dust between the contacts of the headset jack and the port you’re plugging into.  If you occasionally touch the metal contact with your fingers, you are putting oils on the connector.  This in turn allows dust to easily adhere and accumulate on the metal contact.  Dust gets between the points of contact and causes static.

 

How to fix headset static?

First, remove the headset jack from the plug in.  With a can of compressed air, spray into the connector to hopefully remove any dust.  If you don’t have compressed air, you can blow into the connector with short, powerful puffs of air

 

 

 

 

 

 

 

 

 

 

 

With a soft cloth, thoroughly wipe the metal contact to remove any dust and oil residue.

 

 

 

 

 

 

When finished, re-insert the jack into the connector.  Hopefully this resolves the issue and you can use your headset without static.

If it doesn’t, the 3.5mm jack may be damaged and not lining up correctly which causes static as it occasionally makes contact.  Your headset will need to be replaced at that point.

Another cause of static with headsets using the 3.5mm connection is when wires become damaged inside the outer protective cable.  This can happen if you regularly pull or tug on the cable (colored orange in the above pictures) instead of the hard plastic molded assembly.  It’s best to separate the cables only by pulling the hard molded plastic next to the 3.5mm jack while also holding the inline volume controls with your other hand.

In September 2016, Apple release the iPhone 7 and for the first time, removed the 3.5mm headset jack.  This was a much needed move in the industry to replace the 3.5mm headset jack with a more durable and reliable connection.  For Apple, it meant moving to their Lightning Connector.  Other mobile phone and device manufacturers surely will follow Apple’s lead.

6 responses to “How to fix headset static with 3.5 mm stereo jack.”

  1. This also worked for me. I am using a MouKey 6 channel MAMX2 3.5 mm mixer to to route different audio devices to my speakers and have been plagued with static. I tried different cables, adapters and in-line filters, but using compressed air and wiping the connecters has cleaned up my sound quality! I also notice I can determine which connector still needs to be cleaned by slightly rotating the jack within the connector. The connectors that produce static while doing this are the ones that still need to be cleaned better. Connectors that produce no static do not create static when rotating the connector.
    Thank-You!

  2. Seriously, I didn’t even think about dust in the headset jack!
    I tried messing with drivers, loads of random audio apps that said they’d be able to fix the static, etc.
    Eventually I found this and I blew in it a few times sceptically, but desperately, needing to find a fix to this ‘out of nowhere’ static noise that people could here on my microphone.
    And there it was. Perfect again and not a single bit of static. Thank you very much for this!

  3. I do DJ and I have constant humming because of this connection. Is there something I can get to fix this issue? Because it’s causing feedback in my speaker’s constantly

    • Sorry, our speciality is with headsets for telephones and wouldn’t have any advise or fixes for DJ applications.

  4. Thank you so much! I’ve been looking for solutions for my noise problem for hours. Nobody even mentioned dust elsewhere!

Leave a Reply

Your email address will not be published. Required fields are marked *